Will
Forum Replies Created
-
Posts
-
Hi Marcel I think there is a broken connector inside housing where bulb goes in,do you sell replacement indicator
Hmmm, Do you have old thick speaker wires around and some soldering iron ? plus LOTS of very sticky black insulating electric tape ? I would say is it possible to cut the patch of rusted wires and bridge in a new strip of wire inside to complete the circuit ? After all the harness has been stripped down and repaired (donβt forget to isolate the repaired patches with electric tape or ideally shrink wrap tubes Then you can hide the harness with this tape we use in our workshop https://amzn.to/3WrriTK
Does indicator lens on gv bobber unscrew to replace bulb
DO you have standard indicators or LED ones changed up? DIsconnect the indicators by their plugs (incase there is a kink or damage along the harness) Or the relay has gone burst. (We donβt know if you use OEM relay or LED indicator Relay) Also, it would help to strip the bike down to follow all the wires for the indicators because we donβt know if the rain water has caused electric issues or if there is a wire in the bike that is rubbing against the frame (causing a short , then the bike switches off)
Stripped back the wirering loom, found broken wire and lot of moisture,so hopefully will solve issue
Thank you Marcel,be assured if I need any more help or not sure on something you’ll be my first person I contact π
