Bike cuts out – GV125-S

[Will]

Hi guys just a video of the wire loom witch was given me problems,the bike was cutting out on me when I put indicator on,the water had gotten into the wires and also a wire was broken,if this helps anyone who’s having the same problem please share ,I’m riding a 22plate hyosung gv 125s bobber

[♠️ M77]

Hmmm,

Do you have old thick speaker wires around and some soldering iron ?  plus LOTS of very sticky black insulating electric tape ?

I would say is it possible to cut the patch of rusted wires and bridge in a new strip of wire inside to complete the circuit ?

After all the harness has been stripped down and repaired  (don’t forget to isolate the repaired patches with electric tape or ideally shrink wrap tubes

Then you can hide the harness with this tape we use in our workshop

https://amzn.to/3WrriTK

 

 

[Will]

♠️ M77 wrote:

Hmmm, Do you have old thick speaker wires around and some soldering iron ? plus LOTS of very sticky black insulating electric tape ? I would say is it possible to cut the patch of rusted wires and bridge in a new strip of wire inside to complete the circuit ? After all the harness has been stripped down and repaired (don’t forget to isolate the repaired patches with electric tape or ideally shrink wrap tubes Then you can hide the harness with this tape we use in our workshop https://amzn.to/3WrriTK

Quote

Does indicator lens on gv bobber unscrew to replace bulb

[♠️ M77]

There should be a little screw yes to remove the orange glass to change indicator bulb

[Will]

Hi Marcel I think there is a broken connector inside housing where bulb goes in,do you sell replacement indicator

[♠️ M77]

Will wrote:

Hi Marcel I think there is a broken connector inside housing where bulb goes in,do you sell replacement indicator

Quote

Send us an email for a quote and i will see if i can get it

Contact

[Author]

Posts