Forum Replies Created
-
AuthorPosts
-
Cobra2ParticipantAny float-setting could/should be checked “wet”, with a bit of clear hose from bottom, open tap-screw just a half-turn, and see the inside level….
(engine may be cranked a few rounds just to fill the bowls)
Cobra2ParticipantDR same as “D”-speck?
Cobra2ParticipantJust to throw in some confusion? https://hyoriders.club/forums/topic/gv125c-float-question/
Cobra2ParticipantNot bad, some minor scratches, some marks of improper tools…(like: vise-grip marks on axle-nut), been used in all-weather, never really cleaned under the plastic…
Marry her? – no, just another mistress, I guess. But with just enough GO to make longer trips tempting.
Cobra2ParticipantOoooops, I did it again…. 🙂
my 125 found a new owner, and I found a 250… ~ 2012 – GT250R – efi.
Or maybe it is a 2011? Seems odd with the later tail, and older front. Only 7700km, but a bit more “everyday”-used.
And, ofcourse a money-drain… well, that is what winter is for.

Cobra2ParticipantDifferent specks on various sites… but I see it is an all new 60-degree V-engine, vs the older 75-degree…
Cobra2ParticipantHmm…3 valves/cyl… Liquid-cooled, 6-sped-box, EFI? what else differs from the GT-engine? Is there a similar 250?
Cobra2ParticipantCheck if it comes from a bad seal on fuel-outlet, or the level-sender, or a leak in the seams…
Cobra2ParticipantThere is a ventilation/breather-hose connected on the underside of the tank, check if it also has been blocked…
Cobra2ParticipantNo problem keeping it clean, when only used under a blue sky…
Cobra2ParticipantBest way to measure, you can ofcourse use other tools.
But the manual-stated 7 mm, means floats on a “hard” stop. (Not the common way…).

Cobra2ParticipantWith a “make-it-easier”-tool

Cobra2ParticipantThe (above) “wet”-test is the best. The manual can be confusing, but the 7mm measurement is on “full/hard-stop”, – spring compressed. Most often (on other carbs) measurement is on “light-touch”.

Cobra2ParticipantThese TITANIUM-bolts fits really good here..: (one original left for reference)

Also notice the O2/Lambda-boss, – for wide-band lambda, almost a “must” for checking/adjusting jets.
Cobra2ParticipantThanks. Largest annoyance with the dressed bikes, is to undress for simplest tasks & service.
Undresses, but not shy:

Cobra2ParticipantWhen clip-ons gets too <<R>>, put on a “normal” handlebar. Was/is really looking for a even lower/flatter bar, but this works.
With “naked” GT clutch-wire, & extended brake-hose.

@ MARCEL: You will need to get “naked” GT throttle-wire in the shop…
Cobra2ParticipantWashed, ready to go…

Cobra2ParticipantMost important; the oil must be JASO approved.
Cobra2ParticipantNot sure about the GV, but the GT(R) has a 10A fuse in the start-relay.
Cobra2ParticipantSince it is friday..:

-
AuthorPosts