OBW
Forum Replies Created
-
Posts
-
M16 1.5 RH Thread Pitch. At least, that’s what Mr. Sursely at whygostock.com told me, after emailing him. He also sent a link to a castellated nut they sell, (don’t know if posting links is ok here) for about a third the price of the factory part. It does not mention the OD of the nut. I hope it’s 23mm, so I didn’t find that socket for nothing. lol
bastard sized 23mm!
I agree. I am also a little surprised, that there is no safety or other retention for the axle nut. Ideally, It would have been nice to see a castellated nut/split-pin, but that requires drilling a hole through the axle shaft, so I mightΒ drill a axle nut, and safety wire it. This is a longshot, but does anyone know the thread pitch for the axle nut, or where a castellated nut for the GT250R can be sourced?
Just lost the long reply I was typing. Anyway, huge thanks, and a suggestion, that maybe it would be helpful, to have a “sticky ” here, as a reference, listing any fastener sizes outside of a very basic tool set. Especially useful if you are grabbing tools to go somewhere, to get a buddy’s bike on the road. I usually note these things on my bikes in the service manual, but she’s only had the bike a few months. TBH, until she bought it, I’d never heard of Hyosung, but it has won meΒ over completely, A perfect first bike, no terrible habits, honest handling, and easy to repair. I wish my first street bike had been half as good. Thanks again for the help, and the forum.
