Jacob
Forum Replies Created
-
Posts
-
It sure does, I’m going to attempt to bridge that today as well. From my knowledge it works fine due to it not wanting to start up when the clutch lever is disengaged when I’m gear
Also, theirs is spark on neutral but no spark in gear hence why it isn’t igniting and dieing when being shifted into gear. Same case on all other gears also.
iv nailed it down to a faulty neutral safety switch. I adjusted and cleaned where the pin is located and it went into first. I turned the bike off and put some fairings back on and went to kick it over again… truth be told, it cut out from neutral to first/second again. I’ll replace this part and purchase a new chain. Hopefully that dose the trick! Is there any way to bypass it? Can I bridge these wires as Iv done to the kick stand?
Still nothing. Chain has abit of slack but nothing major. Iv bridged the kick stand, added new oil and filter and also looked at clutch sensor and still dosnt shift into gear. Starting to get worried it’s the transition
Awesome help! Just waiting for my partner to get back with the oil and other bibs and bobs. I’ll go down and make sure they’re all allingned. It has 16,000 kms on it so it’s still young but never can be to safe.
I’ll get back with results asap
