Endru

[Endru]

Hello. the sensor (o2) arrived, thank you very much. But unfortunately the same error pops up. I even replaced the sensors from 1 to 2 and vice versa, the same error pops up. Now replace the ECU? Because I have no idea. The same error is often seen on the forums. Is it a factory defect?

[Endru]

Hello Marcel Could you give me your email? Something is not working on eBay. If there was a way to deposit money directly into a bank account.

[Endru]

Hello, one probe is about 1 volt and the other 0.7 volt and sometimes jumps to 0.5 volts. In your opinion, should I replace them because they write differently about these voltages?

[Endru]

So c22 from the manual I downloaded. Thanks a lot for your help and I’ll get back to you when it comes out. And I have two questions; is cylinder 1 counted from the front wheel? Is it possible to copy the manual from which you gave the answer to my question?

[Endru]

Hello, the F1 light blinks 10 times, break 1, break 3, break 2, and so on cyclically, is it c 13? I downloaded the instructions only for my type, there are none, only Regards

[Endru]

Hello, I have a 250gt, probably 2011. How can I check the errors because only the F1 light is flashing and I can’t read the codes. ECU delfi

<hr />

[Author]

Posts