BobberMarley
Forum Replies Created
-
Posts
-
I believe most paddock stands sit under the swingarm of most bikes , you shouldn’t have too much trouble. It can’t hurt to make measurements across comparing your bike to the stand you are after. Some garages locally from you can actually demo their stands and see if they can lift your bike, if their stands work fine, it probably means the average common stand should fit. I say demo the stands with a local garage because I don’t know if it will catch the exhaust cannon that’s on the EFI 125S. I will try to dig more in to this. I suspect the bike already has the mountings underneath for the optional OEM Center Stand if it isn’t already fitted with one. My carby GV’s all had center stands , so i didn’t really need the paddock stands to do most jobs near the rear wheel.
Ok thank you for this will take it too a local place and see what they have.
Unfortunately the Aquila GV doesn’t have a centre stand and only sits on a side stand.
Thanks again for the quick response. Still learning allot about the in’s and outs of bikes so appreciate the help.
Welcome to the site fella! Enjoy the bike fella, they are nice looking bobbers to be fair , just what my own eyes conclude
Do own the older classic GVs though. Pre-Covid era , we did have 2 big meets per year and sometimes people make their own localized meets based on their regions. 2020 meets were cancelled. Since things in 2021 looking to be lifting up , I hope we can do a big meet again this year so that the north and south folk can meet us near midlands or derby since that’s central enough (It might be a repeat of the cancel “Ride #5” in the forum events section) For now I am still a solo rider too haha ,but i do go out for a little ride whenever there is a chance to Got out for a proper ride the other day finally. Looking forward to it staying dry for a bit longer and not getting drenched.
COVID really took the steam out of allot of things but we can see the light at the end of the tunnel now 🙂
I will have to keep my eye out for any info then on next rides when they come up. Thanks for the warm welcome look forward to meeting some people when I can.
Thanks Marcel.
Ended up getting a whole clutch lever Assembly from Sinnis for pretty cheap. Its attached now and looks like new.
Thank you for getting back to me you can close this topic now.
