Register

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: 2007 GT250R – carb help [Solved] #22051
    Sproginoff
    👤 Member
    🖊 Topic Author
    • Topics: 1
    • Replies: 3
    • Country: Australia
    • Bike Model: 2007 Hyosung GT250R

    happy to say she is running amazing now! i adjusted the needles and also set the float heights and gave the jets another good clean and she runs amazing now. thankyou so much for your help and words of wisdom i really appreciate it

    in reply to: 2007 GT250R – carb help [Solved] #22044
    Sproginoff
    👤 Member
    🖊 Topic Author
    • Topics: 1
    • Replies: 3
    • Country: Australia
    • Bike Model: 2007 Hyosung GT250R

    ok so I changed the pilot jets last night and put it ack together this morning. I also checked those O-rings and they are fine. she idles and starts fine now but now it has a new problem. once I got to about 4k it feels like it bogs and struggles to climb in the rpm, low down it feels fine just when i try and get on it

    in reply to: 2007 GT250R – carb help [Solved] #22008
    Sproginoff
    👤 Member
    🖊 Topic Author
    • Topics: 1
    • Replies: 3
    • Country: Australia
    • Bike Model: 2007 Hyosung GT250R

    I ended up getting it to kick over using a bit of spray in the air box but it would rev up to around 6k and come down to about 4K and stay there whilst piping and banging. I didn’t change the pilot jets only the main jets. I will hopefully get a chance to take a look at those o rings this weekend but I should also mention it has an upgraded air filter, muffler and the recommended bigger jets which I think from memory was a 95 and 97.5.

Viewing 3 posts - 1 through 3 (of 3 total)