Dan
Forum Replies Created
-
Posts
-
The screws on the float bowl are bit rusty so I’ve tried not to damage them. I have ordered a new set of stainless steel screws from here and new oringsΒ for the floats from another shop. I will give it another try this weekend again and see if it helps. I will also replace the oil, even thou I just changed it before I started working on the carb π but I prefer to have a healthy engine π Thanks for the help, I will post the update once I replace all the parts.
Hi I used your guide to clean my jets as the bike I have purchased had problems with idle and sluggish power. I presumed it was due to dirty carb. I took it apart found lot of dirt inside the float bowl and clogged jets. Cleaned it up a little bit, put everything together and bike does not start. I can see bit of leakage on the rubber intake , as seen on the pic below, but it is all correctly inserted into the rubber and the clamps are tigthened. What do I do to stop the leakage ? Is it the reason for the bike not starting?
dav
