Reply To: Crank but no start, ecu? – GV250 2012 EFi
Still just cranks, no start, hear a few puffs, then none. This after new wires/ coils/ plug [resister] boots. New plugs, spark blue/ white esp w/ new plugs. Plugs gas soaked as pull out. Has good compression, new stator, new pick up coil. New intake air temp sensor. new battery. coils hv 12.5V etc…
So i suppose, could be iap1 or iap2 sensors, causing too much fuel maybe? or TP sensor, or isc solinoid?
cannot get any Fi light blink codes, light just stays on.
maybe ecu? hard to find one of these 2012 gv250 ecus. [not delphi]
timing or fuel mixture incorrect from ecu ng?