Register
FORUM ARCHIVE: Boards are now read-only as archives. For bike service manual downloads, parts shop, or to read more about the forum changes, tap here to read more....
Viewing 3 reply threads
  • Author
    Posts
    • #20997
      LaserBeam
      Participant

      Are the Rear Swingarm Pivot bearing SPACERS easy to remove? Do these SPACERS fall out or are they hard to remove? (61251HM8100 rear swingarm pivot bearing SPACER).

      Swingarm Pivot SHAFT? Did you have to hit it hard or did the BOLT slide out easily? (61211HM8100 rear swingarm pivot SHAFT)

    • #21001
      ♠️ M77
      Keymaster

      I assume you mean #7 and #8 ? – They just literally slide out , but sometimes may need a little bit of a shake incase it catches the bearing cage lips , these spacer tubes also help the pivot bar roll on the needle bearings easier.

      Normally that area is heavily greased including the pivot bar , bearings, and spacers to avoid seizures.

    • #21003
      LaserBeam
      Participant

      That is good news. Thank you, Marcel. I almost talked myself out of replacing the swingarm but if they come out easy i can reuse them. Hyosung Factory sold me some but did not post them and no refund yet. They are annyoing to communicate with. I transalted my English to Korean so they could fully understand what i think of their lame service. Will never buy from them again. I’ve been waiting and not riden since Winter – it’s almost Summer here.

    • #21004
      ♠️ M77
      Keymaster

      That is good news. Thank you, Marcel. I almost talked myself out of replacing the swingarm but if they come out easy i can reuse them. Hyosung Factory sold me some but did not post them and no refund yet. They are annyoing to communicate with. I transalted my English to Korean so they could fully understand what i think of their lame service. Will never buy from them again. I’ve been waiting and not riden since Winter – it’s almost Summer here.

      Gotta becareful now sad to say “most” of these so-called Hyosung parts sites will be quick take cash but no parts or be lucky to wait a year sometimes!- Could be easier to get a used swingarm off ebay and get it powdercoated with much better paint ? Just an idea!

Viewing 3 reply threads
  • You cannot reply to this topic.