Register
FORUM ARCHIVE: Boards are now read-only as archives. For bike service manual downloads, parts shop, or to read more about the forum changes, tap here to read more....
Viewing 2 reply threads
  • Author
    Posts
    • #6233
      Eric Ashwell
      Participant

      Greetings,

      Have an ’08 GV250 (I’m 3rd owner) and the books are long gone.  Looking to find the correct torque for the front and rear axles.  Bike still has the original tires and has been sitting since 11.  The rubber is like plastic so those need to go, haha.

      Thank you,

      Eric Ashwell

    • #6253
      ♠️ M77
      Keymaster

      Hey,

      It should be 85 FT LBS  for rear axle wheel bolt

      Front wheel spindle bolt should be a 12mm Allen Key Bit and torque it up to 60 FT LBS  (ish)

      Then ofcourse tighten the little bolt thats on the right handside of the fork under neath which stops the front wheel spindle from spinning / anti-vibration.

      Use Google to convert  FT LBS to N.M if you torque wrench uses NM instead of Ft.Lbs

    • #6254
      Eric Ashwell
      Participant

      That’s great info @Marcel – Thank you very much.

Viewing 2 reply threads
  • You cannot reply to this topic.