Register
FORUM ARCHIVE: Boards are now read-only as archives. For bike service manual downloads, parts shop, or to read more about the forum changes, tap here to read more....
Viewing 1 reply thread
  • Author
    Posts
    • #9623
      Dion
      Participant
      1. Heya, so my bike starts and ideas nicely and when I go to ride sometimes rides fine for a bit then it’ll start losing power and only sit around 6-7krpms and won’t go over 70 wont gain any speed then fixes itself, sometimes it’ll do this straight away. Was running sweet for about 1000ks.
      2. Iv cleaned out carby bowels and jets
      3. Checked the plugs
      4. Checked air filter and fuel filter
      5. Cables sweet
      6. Checked for leaks around the intakes what’s else should I be checking
    • #9628
      ♠️ M77
      Keymaster

      It could be the carbs that are waiting for the fuel tap  (as it sounds like it is wanning) (common) and also the fuel pump.

      It could also benefit from some fresh fuel lines all around and also check the “fuel filter ” is facing the right way ( as sometimes a filter facing the wrong way, actually restricts fuel flow) , but replace it anyways if in doubt.

      Also check float height is dead spot on at 7mm (not more , not less ) and also if in doubt, replace the fuel floats , float seat, float valve = That will no doubt ensure the carb now has “uninterrupted” fuel flow as the revs & speed increase.

      The bowls may be clean, how about inspecting the slides and slide needle ?    Here is a mod below that helps the infamous  6-8k dead spot

      [Tutorial] How to adjust Carb Slide Needle (Tuning) – Hyosung GV & GT 125/250

Viewing 1 reply thread
  • You cannot reply to this topic.