Register
FORUM ARCHIVE: Boards are now read-only as archives. For bike service manual downloads, parts shop, or to read more about the forum changes, tap here to read more....
Viewing 4 reply threads
  • Author
    Posts
    • #14730
      Doug
      Participant

      It started out that I noticed the headlight and license plate light weren’t coming on. The 2 small lights on the side of the headlight worked and the brake light was coming on. I had the power on and pressed the pass button and all power went off and now nothing, no dash lights, etc. Sounds like a relay but, which one? Would that be the only thing wrong? The bike sat for a couple years and I have had it running for a month or so. Ran great until now.

    • #14747
      ♠️ M77
      Keymaster

      Relay yes

      Also check the connectors for anything suspicious at the relay zone and the connectors for the lights incase of signs of burns

      Check fuse box , must be 15A

      Check the right and left handlebar switch gears , (open them) look for bad contacts  (you said it was sat for years) , so we’re checking for signs of damaged contacts and also check the connectors for the switches going in to the harness  (for rotting pins) and use “Contact Cleaner” on the entire bike to be sure the harness isn’t getting shorted and all signals are passing through.   Sometimes it helps to remove the harness and re-wrap it with an extra layer of waterproofing tape as the hyosungs don’t like the rain as much as humans do but they will cope with wet weather though like any, it is just their weakness.

    • #14779
      Doug
      Participant

      Which relay? Where is the fuse box?

      Thanks!

    • #14780
      ♠️ M77
      Keymaster

      Under the left side of the rear pillion plastic panel. You will see a 4pin relay that controls lights. A fuse box will be there too ,  15A max.

    • #14845
      Doug
      Participant

      It was 2 fuses. A 20 amp and a 30 amp where toast. Replaced and all good. Thanks for the assist!

Viewing 4 reply threads
  • You cannot reply to this topic.