Intake Pipe O-RING x2 {Inlet Boot Seals} Hyosung 125 250 Models

Intake Pipe O-RING x2 {Inlet Boot Seals} - Various Hyosung 125 250 | UK

Intake Pipe O-RING (Inlet Boot Seals) x2 – GV125 GT125 RX125 GV250 GT250 Hyosung

Price range: £7.99 through £9.99

🌪️ STOP THE AIR LEAKS // VITAL INTAKE MANIFOLD SEALS (X2)

Revs dropping slowly? Hard to start? Over time, heat turns your intake rubber washers into hard pasta, causing air leaks that make your engine run lean and dangerously hot, making a fresh Hyosung intake O-rings swap the absolute safest path to restore a 100% airtight seal during your next maintenance project.

No More Leaks // Block out false air bugs completely to stabilize your idle speeds and secure a smooth throttle connection.
Dual Kit Set // Includes two (2x) matching rubber ring seals to completely refresh both the front and rear manifold ports.
Critical Shield // Direct protection line that stops extreme lean combustion mixtures from damaging your valves or burning pistons.
In Stock // Ready for your fuel system maintenance work. Clean up your induction tracking with fresh, rubber o-rings.

💡 DIAGNOSTIC TIP: If your machine hangs up at high revs after you let go of the handlebar throttle twist grip, or surges erratically on the stand, these inner seals are your number one suspect. Renew them first before messing with your carb settings or EFi sensors!