-
OBW replied to the topic GT250R Axle nut size in the forum 🔧 Hyosung Technical Help 2 weeks ago
M16 1.5 RH Thread Pitch. At least, that’s what Mr. Sursely at whygostock.com told me, after emailing him. He also sent a link to a castellated nut they sell, (don’t know if posting links is ok here) for about a third the price of the factory part. It does not mention the OD of the nut. I hope it’s 23mm, so I didn’t find that socket for nothing. lol
-
OBW replied to the topic GT250R Axle nut size in the forum 🔧 Hyosung Technical Help 2 weeks ago
I agree. I am also a little surprised, that there is no safety or other retention for the axle nut. Ideally, It would have been nice to see a castellated nut/split-pin, but that requires drilling a hole through the axle shaft, so I might drill a axle nut, and safety wire it. This is a longshot, but does anyone know the thread pitch for the…[Read more]
-
OBW replied to the topic GT250R Axle nut size in the forum 🔧 Hyosung Technical Help 2 weeks ago
Just lost the long reply I was typing. Anyway, huge thanks, and a suggestion, that maybe it would be helpful, to have a “sticky ” here, as a reference, listing any fastener sizes outside of a very basic tool set. Especially useful if you are grabbing tools to go somewhere, to get a buddy’s bike on the road. I usually note these things on my bikes…[Read more]
-
OBW started the topic GT250R Axle nut size in the forum 🔧 Hyosung Technical Help 2 weeks ago
Allo! I’m trying to determine the size of the axle nut on my GF’s GT250R, as I’m going to surprise her with a full set of new tools. Along with ratchets & sockets for 1/4, and 3/8 , there is a set of 1/2 inch drive sockets and rachet, and breaker bar, but I think the largest is 22mm, and I’m sure the axle nut is bigger. I looked around here, and…[Read more]
-
OBW became a registered member 2 months ago