Keiran king

So finally I got there and its all working and sorted mot is due in a few days so defo a clean bill of health for it a 650 bill to get her running but we got there thank you so much for the help it’s appreciated marcel

The starter motor is burnt out completetly I’m trying an sv650 one 1999 on mine to see if it works but not sure it does doesn’t seem like it wants to go currently gonna keep trying to see if I get anywhere

I don’t know why it says battery must be auto correct was ment to say starter motor

It was the starter motor the wore that connects to starter wire the connection spins and now the ring has snapped off so its becoming impossible to grab the bottom bolt to undo the top one to change either over but I did bypass it earlier so she is alive

If you do know of any 650 battery’s for fi as the sv one didn’t fit at all for mine

It says it wont fit the 650 model on your ad on ebay

Teah i will do currently Mine I would of thought it needs the rectifier changing (got one on order as we speak) just the as it goes hand in hand with the stator and pickup coil, where its not cranking and there is no bypass on the solenoid I’m gonna change the starter motor aswell (makes sense to get these bits renewed)

I need to get a tester its…[Read more]

Iv also ordered an sv 650 1999 starter motor as this comes under code c12

The rectifier might need changing so will replace this aswell would the gen 1 sv650 fit 1999 model on this bike the coils

iv ordered the sv gen 1 coils aswell should be here next few days

I changed the stator amd pickup coil stol lcomes up with c12 sp will fhamge the ignition coils aswell

Iv found the issue its the code C12 so its the pick up coils im tryi g to find some asap but im insire what ones are needed which years fit the mitsibushi ecu model would it be the 05-09 ei or non ei

Would you be able to get hold of the dealer mode switch or know where i can get one to at all

Its just continious thudding on the battery but fuel pump is still working i cam hear fuel when i try to fire it so surely its something disabling the injector

To be fair i could do with loom that takes a mitsibushi ecu as this is becoming a nightmare really where the loom has been mucked about with, iv had no luck with getting the front injector to work aswell as still not able to get a fault code flicking it on and off a 3 times in 2 times doesnt change anything and i cant find out where it says it in…[Read more]

Here is a picture of what was getting hot it was cleaned up since the picture so now its not white so i did clean it inside but since i put it back on cleaned up its not made a difference (was worth a try)

I found after trying to start it this in the picture was getting hot aswell from the round piece the sensor plugs into

im not sure would it be worth getting a new starter relay as iv replaced the starter solenoid

Iv tried it and nothing vame up ornchamged and i tryed the in the kilswotch on and with it off no difference had been made i have found a fuse 30 amp thays burnt out so gonna change that but i dont think it would make a difference

I have looked in the on the self fiagnosis i dont think there much iption but to change all the relays i dont wamma…[Read more]