-
Graham Walker started the topic Aquila 125 gv carburetors float level in the forum 🔧 Hyosung Technical Help 6 months ago
How do I set-up the carburetors float level, I seem to loose fuel whilst running 10k rpm for a couple of miles. Engine stops running. Slightly open choke press restart and all good. Have fitted the fuel lines,filter and needles supplied from hyoriders club store.
-
Graham Walker started the topic aquila gv125 2005 fuel flow in the forum 🔧 Hyosung Technical Help 7 months ago
having problems with lack of fuel at +9000 rpm. fitted larger filter and fuel lines to carburettors. the fuel level in filter very low and fuel into filter seams slow and remains low in filter. any suggestions appreciated.
-
Graham Walker started the topic gv125 2008 front caliper piston removal in the forum 🔧 Hyosung Technical Help 11 months ago
Advice needed to remove the piston stuck up in front caliper
-
Graham Walker replied to the topic Gv 125 cuts out when throttle applied in the forum 🔧 Hyosung Technical Help 11 months ago
Had the same issue, however seller told me it had your issue. Marcel resolved my issues, basically remove carburettors and clean thoughly with card cleaner and fine wire to ensure all carburettor orifices are not blocked. Un plug EGR Valves and blank off including suction pipe from manifold. I was still loosing power at full throttle up hill so…[Read more]
-
Graham Walker started the topic New member Xativa valencia in the forum ☕️ New Member Intros 1 year ago
Hi everyone, I’m 77 years young, just purchased gv125 non runner. However new parts from Marcel and through carb clean progress is being made. Living in Xativa valencia Spain
-
Graham Walker changed their profile picture 1 year ago
-
Graham Walker replied to the topic New large type fuel filter gv125 Aquila in the forum 🔧 Hyosung Technical Help 1 year ago
Thanks for your information 🐱
-
Graham Walker started the topic New large type fuel filter gv125 Aquila in the forum 🔧 Hyosung Technical Help 1 year ago
<b>filter not fill</b>ing?
-
Graham Walker replied to the topic Removing egr system from gv125 Aquila in the forum 🔧 Hyosung Technical Help 1 year ago
Thanks for your reply, I’ve removed the complete system, no electrical connections. Bike running perfect now after full carburettor strip and clean.😊
-
Graham Walker replied to the topic Removing egr system from gv125 Aquila in the forum 🔧 Hyosung Technical Help 1 year ago
Not until next MOT December 24
-
Graham Walker started the topic Removing egr system from gv125 Aquila in the forum 🔧 Hyosung Technical Help 1 year ago
Can I remove the complete egr system from my bike it’s Europe model 2005.
Regards Graham
-
Graham Walker started the topic CARBURETTOR ACORN ITEM – GV125C in the forum 🔧 Hyosung Technical Help 1 year ago
Hi everyone, just purchased a 2005 gv125 Aquila in Spain. Having troubles re tickover, only runs 6/7k rpm. Ordered many parts but unsure about something called Acorn inside carburettors. Any help identifying the part would be appreciated. gg1946
-
Graham Walker started the topic Acorn – GV125C in the forum 👨🏭 Tutorials | DIY Diagrams Guides 1 year ago
Hi everyone, just purchased my gv125 Aquila 2005. No tickover only runs at 6/7k rpm.
In process of purchasing many parts to try resolving in one shot.
Now I need to find a picture from the forum ACORN. any help appreciated. gg1946
-
Graham Walker changed their profile picture 1 year ago
-
Graham Walker became a registered member 1 year ago